![]() ![]() (Cisco Controller) >config redundancy mode sso (Cisco Controller) >config redundancy unit primary Note: This will reboot the wireless controller. Then the primary unit must be configured as primary and the redundancy mode must be set to sso. (Cisco Controller) >config interface address redundancy-management (RED-IP-WLC#1) peer-redundancy-management (RED-IP-WLC#2) (Cisco Controller) >config interface address management (IP-WLC#1) (SUBNET) (GATEWAY) The wireless controllers have a dedicated redundancy port which must be connected with a standard Cat.6 patch cord.įirst the primary unit must configured with a management, redundancy-management and its peer-redundancy-management (i.e. In this setup one WLC acts as primary unit, the other as secondary unit (so-called Active/Hot Standby). ![]() The new Cisco AIR- CT3504 wireless controller support High Availability with SSO ( Stateful Switch Over). Setting up Cisco 3504 series wireless controller redundancy Setting up Cisco 3504 series wireless controller redundancy |
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |